Crypto · Guide 9 of 12
Liquidation and How to Avoid It
8 min read · Updated 1 October 2026
Liquidation is the forced closing of a leveraged position when its margin runs too low, and understanding leverage, maintenance margin and margin modes is how you keep it from happening to you.
What liquidation is
When you open a leveraged perpetual futures position, you post margin: collateral that absorbs losses. As the price moves against you, your unrealised loss eats into that margin. If losses grow large enough that the remaining margin falls to a minimum level called the maintenance margin, the exchange closes your position automatically. That forced close is liquidation.
Liquidation exists to protect the system. If positions were allowed to lose more than their margin, someone else would have to cover the shortfall. By closing positions early, the exchange limits those losses.
For the trader, liquidation usually means losing most or all of the margin committed to that position, plus possible liquidation fees. It is one of the most common ways new crypto traders lose money.
In VILASA's paper perps, the perp ticket shows a liquidation price preview before you open a position, and it updates as you change leverage, size and margin mode.
The key pieces
| Term | Meaning |
|---|---|
| Notional | Position size in USDT: quantity × price |
| Leverage | Notional ÷ initial margin |
| Initial margin | Collateral required to open the position |
| Maintenance margin | Minimum collateral required to keep it open |
| Maintenance margin rate (MMR) | Maintenance margin as a percentage of notional |
| Mark price | Fair price used for P&L and liquidation |
| Liquidation price | The mark price at which liquidation is triggered |
Maintenance margin rates are usually small, often in the range of 0.4% to 1% of notional for major contracts at modest position sizes, and rise in tiers for larger positions.
How the liquidation price is calculated
Exact formulas vary by venue and also account for fees, but a simplified version for an isolated USDT-margined position is:
- Long: liquidation price ≈ entry × (1 − 1/leverage + MMR)
- Short: liquidation price ≈ entry × (1 + 1/leverage − MMR)
Worked example: long at 10×
- Entry: 60,000 USDT. Leverage: 10×. MMR: 0.5%.
- Liquidation ≈ 60,000 × (1 − 0.10 + 0.005) = 60,000 × 0.905 = 54,300 USDT.
A fall of about 9.5% liquidates the position.
Worked example: short at 10×
- Entry: 60,000 USDT. Leverage: 10×. MMR: 0.5%.
- Liquidation ≈ 60,000 × (1 + 0.10 − 0.005) = 60,000 × 1.095 = 65,700 USDT.
A rise of about 9.5% liquidates the position.
Leverage vs distance to liquidation (long, MMR 0.5%)
| Leverage | Liquidation price (entry 60,000) | Distance from entry |
|---|---|---|
| 2× | 30,300 | −49.5% |
| 5× | 48,300 | −19.5% |
| 10× | 54,300 | −9.5% |
| 20× | 57,300 | −4.5% |
| 50× | 59,100 | −1.5% |
| 100× | 59,700 | −0.5% |
| 125× | 59,820 | −0.3% |
These are simplified figures; fees and funding push the real liquidation price slightly closer. The pattern is what matters. Doubling leverage roughly halves the distance to liquidation. At very high leverage, ordinary price noise can liquidate you within minutes.
VILASA's paper perp ticket offers leverage from 1× to 125×. Try dragging the leverage slider and watching the liquidation price preview move. It is one of the most instructive things you can do in the app.
Isolated margin vs cross margin
The margin mode decides which funds can be used to keep a position alive.
Isolated margin
- Each position has its own dedicated margin.
- If that position is liquidated, you lose only the margin assigned to it.
- Other positions and your free balance are unaffected.
- You can manually add margin to an isolated position to move its liquidation price further away.
Cross margin
- All positions share your available account balance as margin.
- A losing position can draw on your free balance to avoid liquidation.
- This usually pushes liquidation further away for any single position.
- But if the account as a whole runs out of margin, several positions can be liquidated together and you can lose much more of your balance.
Side-by-side
| Feature | Isolated | Cross |
|---|---|---|
| Margin used | Only what you assign to the position | Entire available balance |
| Max loss on liquidation | That position's margin | Potentially much of the account |
| Liquidation distance | Fixed by assigned margin | Further away, depends on balance |
| Best for | Defined-risk trades, beginners | Experienced traders managing hedged portfolios |
Example: the same trade in both modes
Account balance: 10,000 USDT. You open a 20,000 USDT long on BTC at 60,000 with 10× leverage (margin 2,000 USDT).
- Isolated: liquidation near 54,300. If hit, you lose about 2,000 USDT. The other 8,000 USDT is safe.
- Cross: the full 10,000 USDT backs the position. Liquidation would be far lower, roughly where losses consume the whole balance minus maintenance margin, around 30,000 USDT in this simplified case. If that happens, you lose nearly the entire 10,000 USDT.
Cross margin feels safer because liquidation is further away. But the price of that distance is that a single bad trade can take the whole account. For learning, isolated margin makes risk far easier to understand and control.
What happens during liquidation
When mark price reaches your liquidation price:
- The exchange takes over the position and closes it, usually at market.
- Remaining margin, after losses and a liquidation fee, may be lost or partially returned depending on the venue and how the liquidation was executed.
- Many venues maintain an insurance fund that absorbs losses when liquidations cannot be executed at the bankruptcy price. In extreme conditions, some venues use auto-deleveraging, closing opposing profitable positions to cover shortfalls.
In VILASA's simulation, a liquidated paper position is closed and its margin is lost, which is recorded in your position history and trade journal.
How to avoid liquidation
1. Use lower leverage
This is the single most effective step. Leverage of 2× to 3× gives a large buffer against normal volatility. Leverage of 20× and above leaves almost no room for error.
2. Always use a stop-loss
A stop-loss closes your position at a level you choose, well before the liquidation price. A planned exit at a small loss is far better than a forced exit at a large one.
Example:
- Long 0.5 BTC at 60,000, 5× leverage, margin 6,000 USDT, liquidation near 48,300.
- Stop-loss at 58,200: loss = 0.5 × 1,800 = 900 USDT, or 15% of margin.
- Without a stop, a slide to liquidation would cost roughly the full 6,000 USDT.
3. Size by risk, not by leverage
Decide how much you are willing to lose on the trade, then choose position size so that hitting your stop loses that amount. Leverage is simply a result of that decision, not the starting point.
Example: account 10,000 USDT, risk 1% = 100 USDT. Entry 60,000, stop 58,800 (a 1,200 USDT move per BTC).
- Quantity = 100 ÷ 1,200 ≈ 0.083 BTC.
- Notional ≈ 5,000 USDT.
- At 2× leverage, margin ≈ 2,500 USDT; liquidation is far away and the stop does the work.
4. Prefer isolated margin while learning
It caps your worst case per position and makes the liquidation price preview meaningful.
5. Watch funding and fees
In isolated mode, funding paid and fees reduce position margin, nudging the liquidation price closer over time. Check the funding countdown and rate before holding for long.
6. Add margin carefully, not reflexively
Adding margin to a losing isolated position moves liquidation further away, but it also increases the amount you can lose. Only add margin if it is part of your original plan, not as a reaction to a losing trade.
7. Respect volatility
Crypto can move 5% or more in a day and sometimes several percent in minutes, especially around major news. Weekends and low-liquidity hours can bring sudden spikes. Your liquidation buffer should comfortably exceed normal daily swings.
Common mistakes
- Choosing leverage first, then position size.
- Trading without a stop-loss because the liquidation price feels like a stop. It is not; it is the worst-case exit.
- Using cross margin with high leverage across several positions.
- Repeatedly adding margin to a losing position.
- Ignoring funding on long-held leveraged positions.
A practice routine in VILASA
- Open the perp ticket for BTCUSDT.
- With the same size, move leverage from 2× to 10× to 50× and record the liquidation price at each step.
- Switch between isolated and cross margin and compare the preview.
- Open a small paper long at 3× with a stop-loss well above liquidation.
- Journal the trade, including planned stop, liquidation price, funding rate at entry and the outcome.
Key takeaways
- Liquidation is the forced close of a leveraged position when margin falls to the maintenance margin level.
- Higher leverage moves the liquidation price closer; doubling leverage roughly halves the buffer.
- Isolated margin limits losses to the position's margin; cross margin shares the whole balance and can lose much more.
- A stop-loss well before the liquidation price, low leverage and risk-based sizing are the best defences.
- Funding and fees slowly erode isolated margin; check VILASA's liquidation price preview before every trade.
Educational content only · Paper trading is simulated · Not investment advice.
Educational content, not investment or tax advice. Rates and rules change; check the official source before acting on anything here.